Dell Force10 S2410-01-10GE-24P - Page 261

Layer 3 Routing | 261
3. Specify the router ID and enable OSPF for the switch. Set disable 1583compatibility to prevent the
routing loop.
4. Enable OSPF for the ports and set the OSPF priority and cost for the ports.
Force10 (Config)#router ospf
Force10 (Config router)#enable
Force10 (Config router)#router-id 192.130.1.1
Force10 (Config router)#no 1583compatibility
Force10 (Config router)#exit
Force10 (Config)#
Force10 (Config)#interface 1/0/2
Force10 (Interface 1/0/2)#ip ospf
Force10 (Interface 1/0/2)#ip ospf areaid 0.0.0.2
Force10 (Interface 1/0/2)#ip ospf priority 128
Force10 (Interface 1/0/2)#ip ospf cost 32
Force10 (Interface 1/0/2)#exit
Force10 (Config)#interface 1/0/3
Force10 (Interface 1/0/3)#ip ospf
Force10 (Interface 1/0/3)#ip ospf areaid 0.0.0.3
Force10 (Interface 1/0/3)#ip ospf priority 255
Force10 (Interface 1/0/3)#ip ospf cost 64
Force10 (Interface 1/0/3)#exit
Force10 (Config)#interface 1/0/4
Force10 (Interface 1/0/4)#ip ospf
Force10 (Interface 1/0/4)#ip ospf areaid 0.0.0.2
Force10 (Interface 1/0/4)#ip ospf priority 255
Force10 (Interface 1/0/4)#ip ospf cost 64
Force10 (Interface 1/0/4)#exit
Force10 (Config)#exit
Force10 #exit