Dell Force10 S25-01-GE-24P - Four-Post Rack-Mounting with Cage Nuts

22 Installing the S25P
Four-Post Rack-mounting with Cage Nuts
Ensure that there is adequate clearance surrounding the cabinet or rack to permit access and airflow. If you
are installing two S25P systems side-by-side, position them at least 5 inches (12.7 cm) apart. Follow the
steps below to install the S25P chassis into a four-post rack mounting with cage nuts.
Step Task
1
Attach the two rear brackets to the side panels. Align the three holes in the bracket with the three holes on the
S25P chassis, and secure the brackets to the chassis using the screws.
Figure 10 Four-Post Rack-mounting with Cage Nuts
2 Align and secure the adjustable bracket onto the rear bracket.
3 Insert the S25P chassis into the rear of the rack. Position and secure the chassis with two screws into each front
bracket flange and into the rack post.
Figure 11 Four-Post Rack-mounting with Cage Nuts
fn00147f_s25P
Align brackets
Top View of Brackets
P
2
8
2
7
X
F
P
2
6
A
C
1
X
F
P
2
5
A
C
2
A
l
a
r
m
S
t
a
c
k
ID
S
25
-0
1
-
G
E
-
2
4P
fn00147a_s25P
P
2
8
2
7
X
F
P
2
6
A
C
1
X
F
P
2
5
A
C
2
A
l
a
r
m
S
t
a
c
k
ID
S
25
-01
-G
E
-2
4P