Installing the S25P System 9
The Force10 Networks S25P (Cat# S25-01-GE-24P) is a high performance, low cost, stackable, Layer 2
switch/Layer 3 router that supports 24 SFP (small form-factor pluggable) ports, four built-in 10/100/1000
Base-T ports, and up to four 10-Gigabit (10GbE) ports (XFP or CX4), in two expansion slots. As
highlighted in Figure 1, the front panel of the S25P contains a status panel that displays activity of the XFP
ports in the rear panel (Figure 2). For stacking details, see Connecting Stack Ports (optional) on page 25.
Figure 1 The S25P (Front View)
Note: The LEDs labeled AC1 and AC2 are DC1 and DC2 on the S25P-DC (cat.# S25-01-GE-24P-DC).
Figure 2 The S25P (Rear View)
Note: For the back panel of the S25P-DC, see Figure 4 on page 15 and Supplying Power on page 27.
Chapter 1 S25P System Overview
fn00157s25P
OK
AC1
XFP25
XFP26
SFP Ports (1 through 24)
LEDs
Alarm
AC2
XFP27
XFP28
SFP Port LEDs
(1 through 24)
Status Panel
Shared Port IDs (21-24)
Stack ID
Indicator
LED
P28
27
XFP26
AC1
XFP25
AC2
Alarm
Stack ID
RJ-45 Console Port
Catalog # (S25-01-GE-24P)
S25-01-GE-24P
Copper Ports 21-24 with
Speed and Link/Active
Indicator LEDs
fn00158s25P
10-Gigabit Modules or Stacking Modules (optional)
Ground Connector
Dual AC Power Receptacles
Label (Part #, Serial #, MAC Address, Bar Code, FRU #)
Ethernet Port Numbers 25 to 28
(numbered right to left, facing rear)
25262728
To Next Page
Loading...
