Dell FPM185 - Installation Guide; Installing into the Rack

To Next Page

To Previous Page

Installationxxx | xxx3

Installation

Installing into the Rack

This section provides instructions for installing the Dell 1URackmount

LEDConsole Tray in a four-post rack cabinet. The pullout tray assembly

features a keyboard with touchpad and a flat-panel monitor that rotates up from

the console tray for use. An attached cable-management arm routes the monitor,

power, USBand keyboard/touchpad cables to the back of the rack. The monitor's

power supply is installed on the console tray.

Install the console tray using Dell ReadyRails™ IIslide rails in any system

manufacturer's rack cabinets.

For removal instructions, see "Removal from the Rack" on page 23

NOTE: 1U of free rack space is required to mount the 1U Rackmount LED Console Tray.