Steps
1. At an angle, slide the battery into the slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the four screws (M2x4) that secure the battery to the palm-rest and keyboard assembly.
NOTE:
If you are replacing your old battery with the new battery, use the battery cable that came with the old battery.
If you want to replace the battery cable, the battery cable must be purchased separately.
4. Connect the battery cable to the system board.
5. Adhere the tape to secure the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This solid-state drive slot supports only M.2 2280 solid-state drives.
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the removal
procedure.
18
Removing and installing components
To Next Page
Loading...
