Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 card slot.
2. Slide the M.2 2280 solid-state drive into the M.2 card slot.
3. Place the thermal shield on the M.2 2280 solid-state drive.
4. Align the screw holes on the thermal shield with the screw holes on the M.2 2280 solid-state drive and system board.
5. Replace the two screws (M2x4) that secure the thermal shield to the M.2 2280 solid-state drive and the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the wireless card and provides a visual representation of the removal procedure.
20
Removing and installing components
To Next Page
Loading...
