Next steps
1. Install the memory module.
2. Install the wireless card.
3. Install the solid-state drive.
4. Install the rear cover.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Removing the system board (NVIDIA GeForce RTX 3050 Ti
graphics card)
Prerequisites
1. Follow the procedure in Before working inside your computer.
CAUTION: Before removing the system board, give sufficient time for the heat sink to cool down to avoid
injury.
NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. Make the appropriate changes again after you replace the system board.
2. Remove the base cover.
3. Remove the battery.
4. Remove the rear cover.
5. Remove the solid-state drive.
6. Remove the wireless card.
7. Remove the memory module.
NOTE: This procedure only applies to computers shipped with a NVIDIA GeForce 3050 Ti graphics card.
About this task
The following image indicates the connectors on your system-board assembly.
1. Display cable
2. DDS (Dynamic Display Switch) cable
3. Speaker cable
4. Right-fan cable
5. Power-adapter port cable
Removing and installing components
43
To Next Page
Loading...
