4. Turn the computer over.
5. Connect the display cable to the connector on the system board and close the latch.
6. Adhere the tape that secures the display-cable connector latch to the system board.
7. Connect the Dynamic Display Switch (DDS) to the system board.
Next steps
1. Install the rear cover.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Keyboard-controller board
Removing the keyboard-controller board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image(s) indicate the location of the keyboard-controller board and provides a visual representation of the
removal procedure.
Removing and installing Field Replaceable Units (FRUs)
59
To Next Page
Loading...
