Dell G2422HS - Setup and Connection; Setting Up the Monitor and Stand

Setting up the monitor  │  25
Setting up the monitor
Setting up the stand
NOTE: The stand is not factory-installed.
NOTE: The following steps are specifically for setting up the stand that
is shipped with your monitor.If you are attaching a stand that you
purchased from any other source, follow the setup instructions that are
included with the stand.
To set up the monitor stand:
1. R
emove the stand base and stand riser from the packaging cushion.
NOTE: The graphics are used for the purpose of illustration only. The
appearance of the package cushion may vary.
2. A
lign and place the stand riser on the stand base.
3. Open th
e screw handle at the bottom of the stand base and turn it clockwise
to secure the stand assembly.
4. C
lose the screw handle.