Replacing the processor fan
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Connect the fan cable to the system board.
NOTE:
To avoid damaging the cables, ensure to route the fan cable below the heat sink.
2. Align the screw holes on the fan with the screw holes on the system board.
3. Replace the three screws (M2x2.5) that secure the fan to the system board.
Post-requisites
Replace the base cover.
27
Replacing the processor fan 59
To Next Page
Loading...
