Replacing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Align the screw holes on the hinges with the screw holes on the palm-rest and keyboard assembly.
2. Replace the ten screws (M2x4) that secure the hinges to the palm-rest and keyboard assembly.
3. Insert the display cable into the opening next to the hinge.
4. Insert the display cable into the opening next to the hinge.
5. Route the antenna cables along the routing guides.
6. Insert the antenna cables into the opening between the hinges.
33
Replacing the display assembly 69
To Next Page
Loading...
