Removing the eMMC I/O-
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the eMMC card.
Procedure
1 Disconnect the interposer from the hard-drive assembly.
1 hard-drive assembly 2 interposer
2 Remove the two screws securing the eMMC-I/O board to the hard-drive
assembly.
36
To Next Page
Loading...
