Replacing the power and
volume-buttons board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Place the power and volume-buttons board into the slot on the palm rest
and keyboard assembly.
2 Adhere the tape that secures the power and volume-buttons board to the
speaker.
3 Route the power and volume-buttons board cable through the routing
guides on the speaker.
4 Connect the power and volume-buttons board cable to the system
board.
5 Adhere the tape that secures the power and volume-buttons board cable
to the hard-drive assembly.
Post-requisites
1 Replace the battery.
2 Replace the base cover.
48
To Next Page
Loading...
