Removing the power and
volume-buttons board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
Procedure
1 Peel the tape that secures the power and volume buttons-board cable to
the hard-drive assembly.
2 Disconnect the power and volume-buttons board cable from the I/O
board.
3 Remove the power and volume-buttons board cable from the routing
guides on the speaker.
4 Peel the tape that secures the power and volume-buttons board to the
speaker.
46
To Next Page
Loading...
