5 Peel off the tape on the Windows-button board connector, lift the latch and
disconnect the Windows-button board cable from the system board.
1 antenna cables (2) 2 screws (2)
3 display-cable bracket 4 display cable
5 Windows-button board cable 6 tape
7 wireless card
6 Turn the computer over and open the display as far as possible.
CAUTION: Place the computer on a soft and clean surface to avoid
scratching the display.
7 Place the computer face down on a flat surface.
8 Peel off the tape that secures the display cable to the computer base.
9 Remove the screws that secure the display assembly to the computer base.
69
To Next Page
Loading...
