Removing the Windows-button
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the display assembly.
4 Follow the procedure from step 1 to step 2 in “Removing the display panel”.
Procedure
CAUTION: Place the display-panel assembly on a soft and clean surface to
avoid scratching the display.
1 Place the display-panel assembly face down on a flat surface.
2 Remove the screw that secures the Windows-button board to the display bezel.
3 Turn the Windows-button board over.
4 Peel off the tape from the connector on the Windows-button board.
5 Lift the latch and disconnect the Windows-button board cable from the
Windows-button board.
90
To Next Page
Loading...
