Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the display assembly.
5. Remove the display hinge caps.
6. Remove the display bezel.
7. Remove the display hinges.
8. Remove the display panel.
9. Remove the camera.
10. Remove the display cable.
About this task
NOTE: The display back-cover and antenna assembly cannot be further disassembled once all the pre-removal parts
procedures are completed. If the wireless antennas are malfunctioning and are required to be replaced, replace the entire
display back-cover and antenna assembly.
The image below shows the display back-cover and antenna assembly after the pre-removal parts procedures have been
performed for any display back-cover and antenna assembly replacement.
Steps
After performing the pre-requisites, you are left with the display back-cover and antenna assembly.
Installing the display back-cover and antenna assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
100
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
