NOTE: The power-adapter port is secured in place by the right display hinge. There is no screw, tape, or adhesives
securing the power-adapter port to the palm-rest. As a result, technicians should take note of whether the power-
adapter port has fallen out of the system during subsequent removal procedures.
Installing the display assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: Ensure that the display hinges are opened to the maximum before replacing the display assembly on the palm-rest
and keyboard assembly.
The following images indicate the location of the display assembly and provide a visual representation of the installation
procedure.
76 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
