3. Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest
and keyboard assembly.
4. Replace the four screws (M2.5x5) to secure the display hinges to the palm-rest and keyboard assembly.
5. Route the wireless-antenna cables through the routing guides on the palm-rest and keyboard assembly.
6. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
7. Connect the display cable and speaker cable to the respective connectors on the system board.
Next steps
1. Install the wireless card.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Display hinge caps
Removing the display hinge caps
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the display assembly.
About this task
The following images indicate the location of the display hinge caps and provide a visual representation of the removal
procedure.
78
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
