Replacing the Palm Rest
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the palm rest with the screw holes on the
computer base and snap the palm rest into place.
2 Replace the screws that secure the palm rest to the computer base.
3 Adhere the power-button cable to the palm rest.
4 Slide the touchpad cable and the power-button cable into the system-
board connectors and press down on the connector latches to secure
the cables.
5 Close the display and turn the computer over.
6 Replace the screws that secure the palm rest to the computer base.
7 Turn the computer over and open the display as far as possible.
Post-requisites
1 Replace the keyboard.
2 Replace the base cover.
3 Replace the battery.
40
To Next Page
Loading...
