Steps
1. Place the power-button board on the palm-rest and keyboard assembly.
2. Align the screw holes on the power-button board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the power-button board to the palm-rest and keyboard assembly.
4. Connect the power-button cable to the power-button board and close the latch.
5. Connect the power-button board cable to the I/O board and close the latch.
6. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
7. Replace the two screws (M2.5x4) that secure the left-display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power-button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the IO board.
4. Remove the power-button board.
About this task
The following image(s) indicate the location of the power-button with fingerprint reader and provides a visual representation of
the removal procedure.
Removing and installing components
45
To Next Page
Loading...
