3. Lift the display board off the palm-rest and keyboard assembly.
Installing the display board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the display board and provides a visual representation of the installation
procedure.
Steps
1. Place the display board on the palm-rest and keyboard assembly.
2. Align the screw holes on the display board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x2) that secure the display board to the palm-rest and keyboard assembly.
4. Connect the display cable to the display board and close the latch.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the memory.
4. Remove the 2230 solid-state drive or 2280 solid-state drive, whichever applicable.
Removing and installing components
51
To Next Page
Loading...
