Steps
1. Using the alignment posts, place the power-button with fingerprint reader on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2.5) that secure the power-button with fingerprint reader to the palm-rest and keyboard
assembly.
Next steps
1. Install the power-button board.
2. Install the IO board.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
Removing and installing components
47
To Next Page
Loading...
