Steps
1. Remove the two screws (M2.5x4) that secure the left-display hinge to the system board.
2. Pry open the left-display hinge at an angle of 90 degrees.
3. Remove the three screws (M2.5x4) that secure the right-display hinge to the I/O board.
4. Pry open the right-display hinge at an angle of 90 degrees.
5. Lift the latch and disconnect the display cable from the display board.
6. Peel the tapes that secure the display cable to the palm-rest and keyboard assembly.
7. Peel the tape that secures the display-cable connector latch to the system board.
8. Lift the latch and disconnect the display cable from the system board.
9. Gently lift the palm-rest and keyboard assembly off the display assembly
CAUTION:
To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
48 Removing and installing components
To Next Page
Loading...
