Solid-state drive
Removing the 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE: The M.2 card installed will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
ā M.2 2230 solid-state drive + M.2 2230 mounting bracket
ā M.2 2280 solid-state drive
The following image(s) indicate the location of the 2230 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Peel the Mylar that secures the M.2 2230 solid-state drive to the M.2 slot on the system board.
2. Remove the screw (M2x2) that secures the M.2 2230 solid-state drive mounting bracket to the system board.
3. Slide and lift the M.2 2230 solid-state drive assembly off the system board.
4. Flip over the M.2 2230 solid-state drive assembly.
5. Remove the screw (M2x2) that secures the M.2 2230 solid-state drive to the mounting bracket.
6. Lift the M.2 2230 solid-state drive off the mounting bracket.
Installing the 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
18
Removing and installing components
To Next Page
Loading...
