About this task
NOTE: This procedure applies if you are installing a M.2 2230 solid-state drive.
NOTE: Supported card configurations:
● M.2 2230 solid-state drive + M.2 2230 mounting bracket
● M.2 2280 solid-state drive
The following image(s) indicate the location of the 2230 solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Place and align the M.2 2230 solid-state drive on the mounting bracket.
2. Replace the screw (M2x2) that secures the M.2 2230 solid-state drive to the mounting bracket.
3. Flip over the M.2 2230 solid-state drive assembly.
4. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
5. Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
6. Replace the screw (M2x2) that secures the M.2 2230 solid-state drive mounting bracket to the system board.
7. Adhere the Mylar over the M.2 2230 solid-state drive and M.2 slot on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the 2280 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed.
Removing and installing components 19
To Next Page
Loading...
