NOTE: The M.2 card installed will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
● M.2 2230 solid-state drive + M.2 2230 mounting bracket
● M.2 2280 solid-state drive
The following image(s) indicate the location of the 2280 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3) that secures the M.2 2280 solid-state drive to the system board.
2. Lift the M.2 2280 solid-state drive off the system board.
Installing the 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies if you are installing a M.2 2280 solid-state drive.
NOTE: Supported card configurations:
● M.2 2230 solid-state drive + M.2 2230 mounting bracket
● M.2 2280 solid-state drive
The following image(s) indicate the location of the 2280 solid-state drive and provides a visual representation of the installation
procedure.
20
Removing and installing components
To Next Page
Loading...
