Removing the display assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the wireless card.
3 Remove the thermal plate.
Procedure
1 Note the routing of the antenna cables and peel o the cables from the system board.
2 Open the latch and disconnect the display cable from the system board.
3 Remove the display cable from the routing guides on the palm-rest and keyboard assembly.
4 Remove the four screws (M2.5x4) that secure the left and right hinges to the system board and I/O board.
28
52 Removing the display assembly
To Next Page
Loading...
