Steps
1. Align and insert the front-cover tabs into the slots on right side of the chassis.
2. Rotate the front cover towards the chassis and snap the tabs into place.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Optical drive
Removing the optical drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
About this task
NOTE: Depending on the configuration ordered, your computer may not have an optical drive installed.
The following image(s) indicate the location of the optical drive and provides a visual representation of the removal procedure.
16
Removing and installing components
To Next Page
Loading...
