Steps
1. Remove the screw (6-32) that secures the media-card reader bracket to the chassis.
2. Using the screw and the screw-driver push against the media-card reader to release it from the chassis.
3. Slide and lift the media-card reader and its bracket off the system board.
Installing the media-card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the media-card reader and provides a visual representation of the installation
procedure.
Steps
1. Place and slide the media-card reader onto its slot on the system board.
2. Align the screw hole on the media-card reader bracket with the screw hole on the chassis.
3. Replace the screw (6-32) that secures the media-card reader bracket to the chassis.
38
Removing and installing components
To Next Page
Loading...
