3. Lift the optical-drive bezel away from the optical drive.
Installing the optical-drive bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the optical-drive bezel and provides a visual representation of the installation
procedure.
Steps
1. Align the tabs on the optical-drive bezel with slots on the optical drive and snap it in place.
2. Slide the optical-drive tray into the optical drive and close it.
Next steps
1. Install the optical drive.
2. Install the front cover.
3. Install the left-side cover.
4. Follow the procedure in After working inside your computer.
Hard drive
Removing the hard drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
20
Removing and installing components
To Next Page
Loading...
