Installing the antenna modules
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the antenna modules and provides a visual representation of the installation
procedure.
Steps
1. Place the antenna modules on the chassis.
2. Align the captive screws on the antenna modules with the screw holes on the chassis.
3. Tighten the two captive screws (M3) that secure the antenna modules to the chassis.
4. Route the antenna cables through the slot on the chassis and route the antenna cables through the routing guides on the
chassis.
36
Removing and installing components
To Next Page
Loading...
