About this task
NOTE: Depending on the configuration ordered you may have a 2.5-inch or 3.5-inch hard drive installed in your computer.
The following image(s) indicate the location of the hard drive and provides a visual representation of the removal procedure.
Steps
1. Place the computer on its side with the left side facing up.
2. Holding the hard-drive in place, remove the four screws (6-32) that secure the hard drive to the chasis.
3. Disconnect the data and power cables from the hard drive.
4. Lift the hard drive off the chassis.
Installing the hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: You may install either a 2.5-inch or 3.5-inch drive on this computer.
Removing and installing components 21
To Next Page
Loading...
