Steps
1. Align the notches on the solid-state drive with M.2 slot one on the system board.
2. Slide the solid-state drive into the M.2 slot one on the system board.
3. Replace the screw (M2x3) that secures the solid-state drive to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Installing the solid-state drive bracket
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the solid-state drive from M.2 slot one.
About this task
NOTE:
If there is only one solid-state drive in the configuration you ordered, you can install another solid-state drive in the
other M.2 slot. However, you may need a solid-state drive bracket (sold separately; please contact Dell support) to install
the additional solid-state drive.
The following image provides a visual representation of the installation procedure.
Removing and installing components
27
To Next Page
Loading...
