6. Install the WLAN card.
7. Install the memory module.
8. Install the base cover.
9. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the memory module.
4. Remove the WLAN card.
5. Remove the solid-state drive from M.2 slot one.
6. Remove the solid-state drive from M.2 slot two.
7. Remove the fan.
8. Remove the battery (3-cell or 4-cell).
9. Remove the power-adapter port.
10. Remove the display assembly.
11. Remove the I/O board.
12. Remove the touchpad.
13. Remove the coin-cell battery.
14. Remove the heat sink.
15. Remove the power-button board with optional fingerprint reader.
16. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
17. Remove the speakers.
About this task
After performing the steps in the pre-requisites, we are left with the palm-rest and keyboard assembly.
64
Removing and installing components
To Next Page
Loading...
