Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the speakers.
2. Install the system board.
3. Install the power-button board with optional fingerprint reader.
4. Install the heat sink.
5. Install the coin-cell battery.
6. Install the touchpad.
7. Install the I/O board.
8. Install the display assembly.
9. Install the power-adapter port.
10. Install the battery (3-cell or 4-cell).
11. Install the fan.
12. Install the solid-state drive in M.2 slot two.
13. Install the solid-state drive in M.2 slot one.
14. Install the WLAN card.
15. Install the memory module.
16. Install the base cover.
17. Follow the procedure in After working inside your computer.
Removing and installing components
65
To Next Page
Loading...
