9 Slide the touchpad cable into the connector on the system board and close the latch to secure the cable.
10 Slide the hard-drive cable into the connector on the system board and close the latch to secure the cable.
11 Connect the coin-cell battery to the system board.
12 Connect the touch-screen board cable to the system board.
13 Slide the display cable into the connector on the system board and close the latch to secure the cable.
14 Adhere the tapes that secure the display cable and touch-screen board cable to their respective connectors on the system board.
15 Slide the I/O-board cable into the connector on the system board and close the latch to secure the cable.
Replacing the system board
63
To Next Page
Loading...
