Dell Inspiron 5505 - Solid-State Drive-M.2 Slot One; Removing the M.2 2230 Solid-State Drive from M.2 Slot One; Installing the M.2 2230 Solid-State Drive in M.2 Slot One

Solid-state drive—M.2 slot one
Removing the M.2 2230 solid-state drive from M.2 slot one
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: Depending on the configuration ordered, your computer may support a 2230 solid-state drive, or a 2280 solid-
state drive in M.2 slot one.
NOTE: This procedure applies only to computers shipped with a 2230 solid-state drive installed in M.2 slot one.
The following image indicates the location of the 2230 solid-state drive that is installed in M.2 slot one and provides a visual representation
of the removal procedure.
Steps
1. Remove the screw (M2x3) that secures the 2230 solid-state drive to the solid-state drive mounting bracket.
2. Slide and lift the 2230 solid-state drive off M.2 slot one on the system board.
Installing the M.2 2230 solid-state drive in M.2 slot one
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Depending on the configuration ordered, your computer may support a 2230 solid-state drive, or a 2280 solid-
state drive in M.2 slot one.
NOTE: This procedure applies only if you are installing a 2230 solid-state drive in M.2 slot one.
Removing and installing components 23