NOTE: Before installing your 2230 or 2280 solid-state drive, ensure that the mounting bracket is in the correct location.
For more information, see installing the solid-state drive mounting bracket.
The following image indicates the location of the 2230 solid-state drive that is installed in M.2 slot one and provides a visual representation
of the installation procedure.
Steps
1. Align the notch on the 2230 solid-state drive with the tab on M.2 slot one on the system board.
2. Slide the 2230 solid-state drive into M.2 slot one on the system board.
3. Replace the screw (M2x3) that secures the 2230 solid-state drive to the solid-state drive mounting bracket.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the M.2 2280 solid-state drive from M.2 slot one
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE:
Depending on the configuration ordered, your computer may support a 2230 solid-state drive, or a 2280 solid-
state drive in M.2 slot one.
NOTE: This procedure applies only to computers shipped with a 2280 solid-state drive installed in M.2 slot one.
The following image indicates the location of the 2280 solid-state drive that is installed in M.2 slot one and provides a visual representation
of the removal procedure.
24
Removing and installing components
To Next Page
Loading...
