Steps
1. Place the fan on the palm-rest and keyboard assembly.
2. Align the screw holes on the fan with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x2) that secure the fan to the palm-rest and keyboard assembly.
4. Route the I/O-board cable through the routing guides on the fan.
5. Connect the fan cable to the system board.
6. Connect the I/O-board cable to the system board and close the latch.
7. Adhere the tape that secures the I/O-board cable to the system board.
8. Adhere the mylar that covers the fan cable.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
36
Removing and installing components
To Next Page
Loading...
