Steps
1. Place the keyboard on the palm-rest assembly.
2. Align the screw holes on the keyboard with the screw holes on the palm-rest assembly.
3. Replace the 28 screws (M1.2x1.5) that secure the keyboard to the palm-rest assembly.
4. Lift the mylar that covers the screw hole as shown in the bubble located on the image.
5. Replace the screw (M1.2x1.5) that secures the keyboard to the palm-rest assembly.
Next steps
1. Install the system board.
2. Install the power-button with fingerprint reader.
3. Install the I/O board.
4. Install the coin-cell battery.
5. Install the power-adapter port.
6. Install the fan.
7. Install the display assembly.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
48
Removing and installing components
To Next Page
Loading...
