Installing the palm-rest assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the palm-rest assembly and provides a visual representation of the installation procedure.
Steps
To install the palm-rest assembly perform the post-requisites.
Next steps
1. Install the keyboard.
2. Install the system board.
3. Install the power-button with fingerprint reader.
4. Install the pen-garage cable.
5. Install the heat sink.
6. Install the speakers.
7. Install the touchpad.
8. Install the I/O board.
9. Install the coin-cell battery.
10. Install the power-adapter port.
11. Install the fan.
12. Install the display assembly.
13. Install the battery.
14. Install the base cover.
15. Follow the procedure in After working inside your computer.
50
Removing and installing components
To Next Page
Loading...
