Removing and installing components
Recommended tools
The procedures in this document may require the following tools:
• Philips screwdriver #0
• Philips screwdriver #1
• Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type
is restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Base cover Palm-rest assembly M2x4 4
Battery Palm-rest assembly M2x3.5 1
M.2 2230 mounting
bracket
System board M2x2 1
M.2 2280 solid-state
drive/Intel Optane H10
System board M2x2 1
Display assembly Palm-rest assembly M2x5
• Left hinge: 1
• Right hinge: 1
Display assembly Palm-rest assembly M2x3.5
• Left hinge: 1
• Right hinge: 1
Fan Palm-rest assembly M2x2 2
Power-adapter port Palm-rest assembly M2x3 1
I/O board Palm-rest assembly M2x2 1
Touchpad Palm-rest assembly M2x2 2
2
8 Removing and installing components
To Next Page
Loading...
