Removing the display panel
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
NOTE: Piece parts replacement of the display panel using SR tapes and pressure lms is only limited to RFR (Return For Repair
– Depot/CIS/CAR/MIS) service incidents. The complete display assembly (LCD Hinge-Up Display Assembly) must be
dispatched for onsite service incidents.
1 Remove the base cover.
2 Remove the wireless card.
3 Remove the fan.
4 Remove the heat sink.
5 Remove the display assembly.
Procedure
1 Remove the display cable from the routing guide inside the hinge cover.
2 Using a plastic scribe, release the tabs that secure the display-panel assembly to the display back-cover and antenna assembly
3 Lift the display-panel assembly o the display back-cover and antenna assembly.
4 Turn the display-panel assembly over and place it on a at surface with the display facing down.
5 Remove the camera.
6 Remove the display cable.
42
66 Removing the display panel
To Next Page
Loading...
