Adding Parts 53
Undocking the Computer
NOTICE: If you do not have a charged battery installed in the computer when
you undock the computer, you may lose unsaved data.
NOTICE: If you do not use correct undocking procedures, you may lose data
and the computer may not restart.
1
Save and close all open files and exit all open programs.
2 Perform one of the following procedures:
•Click the Start button, and then click Eject PC.
After a few seconds, the computer power light turns off.
• Press the undock request button on the APR.
After a few seconds, the green docking light turns off.
3 Slide the eject/locking lever on the left side of the APR to the eject
position to undock the computer.
docking connector
alignment rails (2)
eject/locking lever
To Next Page
Loading...
