Installing the Display Assembly
1. Place the display assembly on the computer chassis.
2. Adjust the display hinges to align with the screw holders on the computer chassis.
3. Tighten the screws to secure the display assembly to the computer.
4. Connect the display cable to its connector on the system board.
5. Place the metal bracket to secure the display cable and tighten the screws to secure the metal
bracket.
6. Connect the network cable to its connector on the system board.
7. Install the:
a. battery
b. base cover
8. Follow the procedures in After Working Inside Your Computer.
Removing the Display Bezel
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. display assembly
3. Perform the following steps:
a. Peel the plastic adhesive to access the display-bezel screws [1].
b. Remove the screws that secure the display bezel to the display assembly [2].
13
To Next Page
Loading...
