Installing the Power-Connector Port
1. Insert the power-connector port into its place on the computer.
2. Connect the power-connector port cable to its connector on the system board.
3. Install the:
a. display assembly
b. battery
c. base cover
4. Follow the procedures in After Working Inside Your Computer.
Removing the Hard-Drive Assembly
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
3. Perform the following steps:
a. Disconnect the hard-drive cable from its connector on the system board [1].
b. Remove the screws that secure the hard-drive assembly to the computer [2].
18
To Next Page
Loading...
