6. Remove the screws that secure the hard-drive bracket to the hard drive [1] and remove the hard drive
from the hard-drive bracket [2].
Installing the Hard-Drive Assembly
1. Place the hard drive within the hard-drive assembly, align the screw holders, and tighten the screws
to secure the hard-drive bracket.
2. Connect the hard-drive cable to its connector on the hard drive.
3. Place the hard-drive assembly into its slot on the computer.
4. Connect the hard-drive cable to its connector on the system board.
5. Tighten the screws to secure the hard-drive assembly to the computer.
6. Install the:
20
To Next Page
Loading...
