Installing battery
Steps
1. Insert the battery into the slot on the computer.
2. Route the battery cable through the routing channels.
3. Tighten the M2*6 captive screw to secure the battery to the computer.
4. Connect the battery cable to the connector on the system board.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Solid State Drive — optional
Removing optional M.2 Solid State Drive (SSD)
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the SSD card:
a. Peel the adhesive Mylar shield that secures the SSD card [1].
NOTE: Need to be removed carefully in order to be reused on the replacement SSD.
b. Remove the M2*3 screw that secures the SSD to the computer [2].
c. Slide and lift the SSD from the computer [3].
Removing and installing components
21
To Next Page
Loading...
