Power connector port
Removing power connector port
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the power connector port:
a. Remove the M2*3 screw that secures the display cable to the computer [1].
b. Disconnect the power connector port cable from the connector on the system board [2].
c. Remove the M2*3 screw to release the metal bracket that secures the power connector port [3].
d. Lift the metal bracket [4].
e. Lift the power connector port away from the computer [5].
Installing power connector port
Steps
1. Align the power connector port along the grooves on the slot and push it down.
2. Place the metal bracket on the power connector port.
3. Tighten the M2*3 screw to secure the power connector port to the computer
4. Connect the power connector port cable to the connector on the system board.
5. Tighten the M2*3 screw to secure the display cable to the computer.
34
Removing and installing components
To Next Page
Loading...
